Fenoterol hydrobromide/Ipratropium bromide

Pressurised metered-dose inhalers (pMDIs) are associated with global warming potential values as they contain a hydrofluoroalkane (HFA) propellant, whereas the Respimat^® Soft Mist™ inhaler is propellant-free. The original disposable Respimat has recently been updated to provide a reusable device that is similar in performance and use but is more convenient to patients and reduces environmental impact. This study compared the product carbon footprint (PCF) of Respimat (both disposable and reusable) and pMDIs to understand life cycle hotspots, and also to determine the potential quantitative environmental benefits of a reusable Respimat product.

PCFs of four inhalation products-tiotropium bromide (Spiriva^®) Respimat, ipratropium bromide/fenoterol hydrobromide (Berodual^®) Respimat, Berodual HFA pMDI and ipratropium bromide (Atrovent^®) HFA pMDI-were assessed across their whole life cycle.

Data show that Respimat inhalers have a lower PCF (carbon dioxide equivalent per kilogram) than HFA pMDIs: pMDI Atrovent 14.59; pMDI Berodual 16.48; disposable Spiriva Respimat 0.78; disposable Berodual Respimat 0.78. Approximately 98% of the pMDI life cycle total is due to HFA propellant emissions during use and end-of-life phases. The impact of the material used for the Respimat product outweighs the impact of the material used to make the empty cartridge. Furthermore, compared with the single-use device over 1 month, the PCF of Spiriva Respimat was further reduced by 57% and 71% using the device with refill cartridges over 3 and 6 months, respectively.

Together, these data suggest that Respimat inhalers, and in particular the new reusable inhaler, can reduce the environmental impact associated with inhaler use.

Boehringer Ingelheim.

The sudden expansion of gas at the outlet of the jet (pneumatic) nebulizer significantly reduces the temperature of the solution, which may provoke bronchospasm, therefore it is recommended to use modern pneumatic inhalers equipped with a thermostat or a universal thermal attachment that allow to obtain a higher temperature aerosol, i.e. thermo-aerosol. The research was carried out for model Newtonian fluids. The droplet diameters of the aerosol spray were investigated using a Spraytec aerosol particle size measurement system. Analysis of the obtained results showed that the increase in solution viscosity caused a decrease in mean droplet diameters and prolonged nebulization time. The analysis of experimental data made it possible to propose a correlation equation describing the mean diameter of the droplets depending on the properties of the liquid and the flow conditions in the thermostated medical nebulizer. The obtained data contributes to a better understanding of the complex liquid atomisation process and can be helpful in the design of medical nebulizers and pharmaceutical preparations.